3 Rolls

MAV Plate Rollsreqquote

Davi 3Roll MAV Davi 3Rolls MAV
Davi 3Rolls MAV long

MAV Plate Rolls Range:


The most advanced plate roll for thickness greater than 60-80 mm,(2 – 3 Inches). A machine apart, with many exclusive benefits, the best solution available in “super heavy applications”.


Press-Roll Design:


MAV is the absolute easiest 3 roll to operate, as it works exactly like a press-brake. Like a ram, the top roll moves up and down and the material, sits on the side rolls like a bed.


    • Up to 6000mm long
    • 13mm to 82mm Rolling thickness
    • Available with a range of CNC controls


MCO – Three Roll Double Pinch


Davi 3Rolls MCO 2 Davi 3Roll MCO2
Davi 3Roll MCO The most common design in the industry, with the top roll fixed, and the two side rolls that move up and down to pre-bend the edges, and to roll the plates. 
The most inexpensive roll for plates from 15-20 mm (5/8 – 3/4 inch) thickness, up to     80-100 mm (3 – 4 Inch), and more, it is recommended for limited production volumes.

MCO Plate Rolls Range:

4 Rolls

MCA – Four Rollreqquote


 Davi1 4Rolls MCA  Davi 4Rolls MCA 2
 Davi 4Rolls MCA 3  


Innovative and exclusive in design, to roll plate up to 10-15 mm (1/2 inch) thick. 
Accurate, fast, easy and intuitive, it is the most high-tech plate roll for “light gauge” in the market. 

MCA – Four Roll Range:


MCB – Four Rollreqquote

Davi_4Rolls_MCB_5.jpg Davi_4Rolls_MCB_4.jpg

MCB – Four Roll Range:


The most advanced machines to roll plates from 15-20 mm (5/8 – 3/4 inch), up to 80-100 mm (3 – 4 inch) thick and more. Accurate, easy, intuitive and fast (up to 6 meters – 20ft per minute), it is the most high-tech in “high productive mid-heavy application” in the market.



One Phase Cycle


No need to pre-bend the two edges of the plate first, and then roll, as on any three roll.


Angle Roll MCP reqquote

Davi_Rolls_4.png Davi_Rolls_1.png

Angle Roll MCP:


The DAVI three roll MCP section roll was engineered to answer the requirements of very demanding customers, who need to bend parts of large and extra large dimensions with very strict tolerances. 

In each sector of applications: from aerospace to shipyard, from automotive to structural, engineers are always proposing solutions of more sophisticated bent parts, made out of hard material that can only be obtained by bending non-standard profiles at very tight diameters with strict tolerances.

Wind Tower Bending Machinereqquote

Davi_wind_towers_3.png Davi_wind_tower.jpg

Wind Tower Bending Machine:



The range of plate thicknesses used to manufacture the towers and foundations for the off-shore wind industry is increased significantly, compared to the on-shore towers, reaching over 140 mm (5.5”) for the foundations and 100 mm (4”) for the towers.